Winterizing Your Fresh Water System

Make sure you winterize properly to avoid broken waterlines, leaks or other problems over the winter - or in the spring when you're ready to go out and play!

Your unit may have a winterizing hose and pump bypass built in.  If not, you will require a winterizing hose to hook up to the suction side of your water pump.

* If you have any inline water filters remove and bypass before starting.

* Drain the fresh water holding tank.

*Drain and flush the grey and black holding tanks.  If your RV doesn't have a built in tank flushing system clean the black tank out with a wand, or use a product like Flush King that allows you to clean both the black and gray tanks.  Lubricate the termination valves with WD40.

* Drain the water heater.  Remove the drain plug and open the pressure relief valve.  CAUTION:  Never drain the water heater when it is hot or under pressure.

*Open all hot and cold faucets.  Don't forget the toilet valve and outside shower!

* Locate and open the low point drain lines.  There will be one for the hot and cold water lines.  Using the water pump will help force water out, but turn it off as soon as the system is drained.

*Recap all drains and close all faucets.

* By-pass the water heater.  If you do not have a by-pass kit installed the water heater will fill up with anitfreeze before it goes through the water lines, wasting six gallons of antifreeze.

* Install a water pump converter kit, or disconnect the inlet side of the water pump (the line coming from the fresh water holding tank).  Connect a piece of clear tubing to the inlet side of the pump and put the other end into a one gallon container of Non-Toxic antifreeze.  

* Turn the water pump on nad pressurize the system.  Starting with the closest faucet, slowly open the hot and then the cold valves until anitfreeze appears.  Refill/replace the antifreeze container as required.

* Repeat this process on all faucets from the closest to the farthest away.  Don't forget the outside shower, if equipped.

* Flush the toilet until antifreeze appears.

* Turn the water pump off and open a faucet to release the pressure.  Go outside to the city water inlet.  Remove the small screen over the inlet and push in on the valve with a small screwdriver until you see antifreeze.  Replace the screen.

* Pour a cupful of antifeeze down each drain.  Pour a couple of cups in the toilet and flush into the holding tanks.

* If your water heater has an electric heating element make sure it is turned off.  This will protect the element if the unit is plugged in while being stored.

* Make sure all the faucets are closed. 

*  Consult your owner manuals for winterizing icemakers and washing machines.

Congratulations!  Your unit is now winterized!!